The servo can be configured to work in both traditional and continuous rotation modes.
Meet the Dual Mode ‘SUPER
| Weight | 58g |
|---|---|
| Gear Ratio | 67:1 |
| Output Shaft Style | 25 Tooth Spline |
| Voltage Range | 4.8V ~ 7.4V |
| No-Load Speed (4.8V) | 0.055 sec/60° (180RPM) |
| No-Load Speed (6.0V) | 0.043 sec/60° (230RPM) |
| No-Load Speed (7.4V) | 0.035 sec/60° (290RPM) |
| Stall Torque (4.8V) | 4.0 kg.cm (55 oz-in) |
| Stall Torque (6.0V) | 4.7 kg.cm (65 oz-in) |
| Stall Torque (7.4V) | 5.4 kg.cm (75 oz-in) |
| No-Load Current (4.8V) | 190mA |
| No-Load Current (6.0V) | 200mA |
| No-Load Current (7.4V) | 230mA |
| Stall Current (4.8V) | 2000mA |
| Stall Current (6.0V) | 2500mA |
| Stall Current (7.4V) | 3000mA |
| Max PWM Range (Default) | 500 - 2500μsec |
| Max PWM Range (Continuous) | 1000 - 2000μsec |
| Travel per µsec (Default) | 0.15°/μsec |
| Max Travel (Default) | 300° |
| Pulse Amplitude | 3-5V |
| Direction | Clockwise w/ Increasing PWM Signal |
| Deadband Width | 4μsec |
| Motor Type | Brushed DC |
| Feedback Style | 5KΩ Potentiometer |
| Output Shaft Support | Dual Ball Bearing |
| Gear Material | Steel |
| Wire Length | 300mm |
| Wire Gauge | 22 AWG |
| Connector Type | 3-Pos TJC8 Servo Connector [MH-FC] |
SPEED’ Servo. This servo is essentially an even faster version of the 2000-0025-0003 ‘SPEED’ Servo, reaching speeds of up to 290RPM!
Just like the other 2000 Series servos, this servo boasts two different modes which allow it to fill a variety of roles on your robot or project. In the default mode, the servo is able to rotate 300 degrees while having positioning feedback. In this mode, the PWM signal will determine the position of the servo. Using the 3102 Series Dual Mode Servo Programmer (1-1) the servo can be toggled into continuous rotation mode. In this mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
Drawings
